17Kg Emulzer Emilkote Bitumen Emulsion Waterproofing

Emulzer Emilkote Bitumen Emulsion Waterproofing – It is a ready to use waterproofing material obtained by mixing water and bitumen with special methods. By the evaporation of the water it contains, it forms a waterproof layer on the surface it is applied.

Usage Area: It is used on all horizontal and vertical surfaces in closed damp environments such as foundations, underground storehouses, and basements to insulate water leakage. For the applications requiring durability against higher water pressure, and on cracked surfaces, it must be reinforced with materials such as fiber gloss, polyester felt, reinforcing fabric etc.

Emilkote can be used as an undercoat prior to bituminous membrane applications of any brand. Thanks to its superior adherence characteristics, it allows the bituminous membranes under which it is applied to adhere firmly to the surface they are applied, leaving no gap in between. The alum material obtained by mixing Emilkote with sieved fine sand and cement is applied with a trowel to smooth out and level the surface, or to provide a prolective coat over insulation. In parquet flooring applications with
hot bituminous materials, it is applied as an undercoat over the alum. It is applied to construction molds to be able to disassemble molds easily and to provide a smooth surface.
It prevents concrete curing water from damaging molds

ADVANTAGES: It is very economical. Due to its inflammable and non-toxic characteristics it can be safely used in closed spaces, Because it contains water, it enables good adhesion even when the surface is moist.

By the evaporation of the water it contains, it forms a waterproof and water – insoluble layer.
APPLICATION: Emilkote is a cold applied material. After having mixed with water with a ratio of approximately 20%, it is applied with a bitumen brush, roller, or pistol.

Depending on the weather conditions, it dries in approximately 4-5 hours. It should not be applied in rainy weather, or at temperatures below +5°C. Each coat must be applied only after the preceding one is completely dry.